C-TEC CAST Input Output Module

SKU: CA731 Category:
Monthly payment from 7.30€ / 12 months

C-TEC CAST Input Output Module

  • Certified to EN54-17 & 18 by the LPCB.
  • Incorporates the functions of a switch monitor, zone monitor, simple switch interface and output unit.
  • Can be configured to monitor any combination of:-
    • Up to 20 conventional detectors & 10 MCPs
    • Any normally open switch with an EOL resistor fitted.
    • A simple normally open or closed switch (non-fault monitored).
  • Onboard short-circuit loop isolator.
  • 5.5mA Alarm Current.
  • Indicators for Loop polling, input faults and relay status.
  • Can switch 1A@30V DC (or 0.3A@125V AC)
  • Includes volt free changeover contacts that can be used to trigger rollershutter doors, gas shut-off valves, smoke vents, etc.
  • Mountable on a C-TEC NCP-26 surface box or a standard UK 25mm double gang back box (not supplied).

85.89€

Tallinna laos: 25+
Tartu laos: 12

Description

Approvals/certifications Certified to EN54-17/18 by the LPCB.
Compatibility Compatible with C-TEC’s XFP/ZFP CAST Addressable Fire Panels.
Application/operation Incorporates the functions of a switch monitor, zone monitor, simple switch interface and output unit in one device.
Supply/operating voltage 27 to 40V DC.
Quiescent current 1.3mA.
Activation current 5.5mA.
Auxiliary relays One volt-free single pole changeover relay rated at 1A @ 30 VDC (or 0.3A @ 125 VAC). Non-monitored. Clean contact.
Auxiliary inputs One monitored input that can be set to operate as: (1) a single zone monitor to support up to 20 ActiV detectors and 10 MCPs or (2) a monitored normally-open switch, triggered by a 470R.
Indicators Active (Lit Red): relay activated; monitored zone triggered or monitored switch closed; Polling (Flashing Red): communication check with the panel; Input Fault (Lit Yellow): fault detected on the monitored zone/switch.
Connections Six 45º screw-type connectors that can take 0.5-2.5mm2 cable: +Ve & -Ve Loop In; +Ve & -Ve Loop Out; Zone +Ve & -V. Also includes N/O, N/C & C relay connections.
Product dimensions (mm) 147 W x 87H x 22 D mm. Can be mounted on a standard 25mm UK flush or surface double gang back box.
Construction & finish ABS Polycarbonate plate with a 200 micron two-tone grey velvet polyester label with red and white detailing.
IP Rating IP40 when correctly installed.
Weight 122g.
Operating conditions/temperature -10ºC to +55ºC.

Reviews

There are no reviews yet.

Be the first to review “C-TEC CAST Input Output Module”

Related products